Safe Use And Cleanup Of Seeding Machine

　　When the seeding machine starts, the power output shaft should be engaged first, and then the working gear should be engaged. While softly releasing the clutch pedal, pull the hydraulic control handle to make the blade of the seeding machine slowly enter the soil, and then increase the throttle until the normal tillage depth. Before starting, it is forbidden to put the seeding machine into the soil and rush into the soil to avoid damage to the parts.

　　When the seeding machine starts, the power output shaft should be engaged first, and then the working gear should be engaged. While softly releasing the clutch pedal, pull the hydraulic control handle to make the blade of the seeding machine slowly enter the soil, and then increase the throttle until the normal tillage depth. Before starting, it is forbidden to put the seeding machine into the soil and rush into the soil to avoid damage to the parts.

　　In the process of field work, you should pay attention to whether there are noises when the working parts are running. Once found, you should stop and check immediately, find out the reason and eliminate it before re-operation. The two ends of the universal joint should be close to the level when working, and the angle between the universal joint and the horizontal should be less than 30 degrees when lifting. If the left and right horizontal levels of the seeding machine are inconsistent, adjust the triangle rod to shorten or extend the right rod to reach the horizontal level. The universal joint should be removed during daily transportation. The seeding machine must be raised when turning and reversing the ground, otherwise the blade will be deformed or broken, and the rotary cutter will be damaged seriously. When transferring plots, the seeding machine should be raised to the highest position while cutting off the power of the PTO shaft. If the transfer distance is far, it must be fixed with a locking device.

　　The seeding machine should be shut down to check and clean the blades every 3-4 hours. During the inspection and cleaning, many drivers did not put out the fire on the engine, and only stopped and stopped the plow, which often caused unfortunate accidents. The equipment involved in the accident is generally old cars with aging parts and poor performance. When an accident occurs, the body is often in a head-down position, and the gear lever that controls the clutch sleeve is too old, and the vibration force of the body is too large. Occasionally, the clutch sleeve will automatically slide down, causing the seeding machine to automatically engage in gear. To avoid such accidents, the driver must be optimistic about the topography of the parking when cleaning up the debris on the seeding machine. For the sake of safety, the gear handle of the control clutch sleeve can be tied with a rope in advance to prevent it from moving. When cleaning, attach the sickle with a handle that is more than two meters long, and clean it more than 1 meter away from the seeding machine, and be vigilant, so that there is no danger. In order to reduce the direct contact of crop straws and weeds with the colter shaft, the two bolts can be lengthened by about 10 cm when the two colters on the far left and right of the colter shaft are installed, which can eliminate the phenomenon of reducing the colter shaft entanglement.